![]() Don't keep the heat gun aimed at one spot too long or get too close to the heat-shrink sleeve or you will melt the sleeve. Rotate the racquet while slowly moving the heat gun up the handle. Hold the sleeve firmly in place at top and begin heating from the bottom, keeping the heat gun 3-4 inches away.Slide the heat shrink sleeve over the butt cap and up the handle, overlapping the handle end by about 3/8 inch.Remove grip and staple, being careful not to tear the grip if reusing. ![]() Razor Knife - to trim heat-shrink sleeve. ![]() Needle-nose pliers and/or a narrow screwdriver - to remove staple that secures the wrap grip onto the handle (if applicable). ![]() Tools Needed for Installation (not included): You will need a heat gun or very hot hair dryer and a few tools for this procedure. These sleeves are easy to use and retain the handle's bevels. This Heat Shrink Sleeve will increase the grip by 1/8 inch (i.e., one grip size for tennis, 1/2 grip size for racquetball). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |